[bars] 2.182 MHz xtals?

[Eric A. Cottrell]

Hello,

X3 is used for LSB and X2 is used for the other modes. I suspect they 
flip the IF spectrum to handle LSB by doing high-side injection. That 
would make the frequencies more like 2138 KHz and 2252 Khz.

73 Eric

On Sun 6/2/2019 2:25 PM, Andy Wallace wrote:
> A friend is restoring an RME 6900 receiver and someone moronically removed the two 2.18 MHz IF xtals. Would anyone have a pair in the junkbox? The manual does not say the exact freq, just an RME part number, but I am guessing since 2.182 was the old maritime distress freq that was what RME used, perhaps they were common in surplus. If someone has a pair that’s “close” perhaps the IF can be tweaked a bit to match.
>
> Thanks
> Andy
> KA1GTT at arrl.net
>
>
> _______________________________________________
> bars mailing list
> bars at w1hh.org
> http://mail.w1hh.org/mailman/listinfo/bars_w1hh.org

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus